Use 'ip' and 'ss' Commands
Use the ip
and ss
commands to view a list of network interfaces and information for IP addresses.
Although the ifconfig
command and the netstat
command work on Photon OS, VMware recommends that you use the ip
or ss
commands. The ipconfig
and netstat
commands are deprecated.
For example, to display a list of network interfaces, run the ss
command instead of netstat
. To display information for IP addresses, run the ip addr
command instead of ifconfig -a
.
Examples are as follows:
USE THIS IPROUTE COMMAND INSTEAD OF THIS NET-TOOL COMMAND
ip addr ifconfig -a
ss netstat
ip route route
ip maddr netstat -g
ip link set eth0 up ifconfig eth0 up
ip -s neigh arp -v
ip link set eth0 mtu 9000 ifconfig eth0 mtu 9000
Using the ip route
version of a command instead of the net-tools version often provides more complete and accurate information on Photon OS. Examples are as follows:
ip neigh
198.51.100.2 dev eth0 lladdr 00:50:56:e2:02:0f STALE
198.51.100.254 dev eth0 lladdr 00:50:56:e7:13:d9 STALE
198.51.100.1 dev eth0 lladdr 00:50:56:c0:00:08 DELAY
arp -a
? (198.51.100.2) at 00:50:56:e2:02:0f [ether] on eth0
? (198.51.100.254) at 00:50:56:e7:13:d9 [ether] on eth0
? (198.51.100.1) at 00:50:56:c0:00:08 [ether] on eth0
Last modified August 1, 2024: Merge pull request #1562 from naltanov/photon-hugo (a784a46)